Introduction
We built the SIDEL 2002406262 infrared heating lamp to be one of those rare parts that just works. Plug it in, and it’s ready to go on your PET blow molding line. It was designed to fit right into the physical and electrical setup of most machines out there, so when a lamp burns out, you don’t have to go on a hunt for some obscure, proprietary replacement.
The Tech, Without the Headache
Let’s get into the details, but keep it real. The SIDEL 2002406262 is a 2500W, 400V shortwave infrared lamp packed into a 300mm tube. That power level isn’t random. It’s exactly what’s needed to deliver a sharp, focused blast of heat right where the preform needs it, without turning the whole machine into a space heater. And the 400V rating? That was a deliberate choice. It lines up perfectly with the standard industrial control panels in most blow molding cells. When it runs at the right voltage, the current draw stays predictable, which means less strain on the machine’s entire power system. Just keep in mind, your cooling system needs to be ready for the extra warmth during those long shifts.
Built to Take a Beating
Here’s the thing about a lamp on a production line: it gets hot, it gets cold, and it does it over and over again. That’s why we went with a halogen-filled quartz tube. It can handle the shock of those rapid on/off cycles without blinking. The shortwave output means you get instant response and tight control over the heating window, which is crucial when you’re trying to perfectly time the preform heating phase. The lamp uses an R7s connector—a standard, double-ended pin setup. We chose it because it’s mechanically solid and electrically reliable, no matter the brand of the machine. The shape and pin spacing are designed to drop right into the ceramic sockets you already have, with zero fuss or modifications.
What It Feels Like on the Floor
On a PET blow molding line, you need heat that’s consistent and you need it right now. The SIDEL 2002406262 delivers. It heats up fast, and the output is repeatable, so you can keep your cycle times steady. Because it’s built as a cross-brand replacement, you can keep just one spare on the shelf and know it’ll work for several different machines. Installation is a simple swap. Line up the pins, pop the tube in, and wire it up. It’s built tough enough to handle the heat and the constant vibration of the shop floor, but like any hardworking part, it still needs proper airflow and a healthy socket to give you its full lifespan.