Sidel SBO 16 Series 2 IR heater bulb

Tue, 07 Jul 2026 05:20:02 +0800

Let’s cut to the chase. The Sidel SBO 16 Series 2 IR heater bulb is built for one thing and one thing only: throwing serious, focused heat right where you need it inside a blow molding machine. We designed it to be a straight swap for most systems out there. Plug it in, and you’re good to go. No more being held hostage by brand-specific parts.

SIPA SFR 16 infrared heater

Wed, 24 Jun 2026 03:28:19 +0800

Out on the blow molding line, uneven preform heating doesn’t just throttle your speed—it creates scrap you can see and touch. When the heating tunnel can’t hold temperature across the neck and body, stretch becomes inconsistent, biaxial orientation goes sideways, and you end up with a pallet of off-spec bottles. The SIPA SFR 16 infrared heater is built to stop that drift and keep your heating profile honest, shift after shift. What you’re actually getting, technically The SFR 16 is a short-wave infrared emitter, built around a quartz tube and a high-purity halogen filament, tuned for fast response and repeatable output. It runs on the same voltage your SIPA blow molder expects, and it uses the same R7s base and mounting geometry as the OEM unit—so it’s a straight 1:1 swap. In practice, you can change the lamp in minutes without re-engineering the heating zone or re-mapping the whole tunnel. Here’s why it matters in stretch blow molding: time is heat, and heat is control. The SFR 16 hits target temperature fast, then holds it with tighter stability. That gives you more consistent preform heating and more predictable bottle weight. The payoff is fewer rejects and fewer stops to chase adjustments. Energy use drops because the heater cycles more efficiently and wastes less heat outside the preform zone. Plants running the SFR 16 typically see 15–20% energy savings on the heating section, and lamp life stretches to 5,000–6,000 hours—fewer changes, less downtime, less maintenance labor. Installation is straightforward, but alignment is not optional. The lamp has to sit in the reflector exactly as specified; even a small offset shifts the hot spot and can push heating unevenness right back into the bottle. Keep the reflector clean and intact—pitting or oxidation scatters energy and steals output. And one more point: short-wave IR is intense. Use proper shielding and heat protection around the lamp ends so you don’t cook nearby components.

16 on Your Warm IR Heating Haven

Sidel SBO 16 Series 2 IR heater bulb

SIPA SFR 16 infrared heater